Of Bellflower's 23,802 occupied homes, only 9,352 are lived in by their owners, which makes it the most renter-heavy place we cover. Plumbing here tends to open with a question: whose job is the repair? Below you will find the answer, plus the four water companies. Other cities are on the service areas page, and requests begin on the quote request page.
Renting in Bellflower: who handles a plumbing problem?
Your landlord or property manager, in writing, before anything else. Most leases and California's rental rules put the building's plumbing on the owner, and a repair a tenant arranges alone can create disputes over who pays. Save a dated note with photos that shows what is failing and since when.
When a serious problem, such as no hot water or a leak damaging the unit, goes unaddressed, read up on California's habitability rules and local tenant resources. Legal advice is outside what this site offers. What can be arranged is arrange a plumber to visit and quote the repair, and the owner then decides whether to approve it. Before writing to the owner, run through the checks in why there is no hot water.
How many Bellflower homes are in apartment buildings?
A lot of them. About 6,500 of Bellflower's 24,683 housing units are in buildings of 10 or more units, roughly one in four (ACS 2024 five-year estimates). That is a sizable share, and it shapes the work. Shared stacks, common water heaters and older galvanized risers appear far more often than they do in a street of detached houses.
Water takes the lowest path, so a drip in one apartment can surface as a stain in the unit below, and a leak is rarely one household's problem. While you wait for help, move belongings clear, keep away from wet light fixtures and report the leak. More is on the ceiling leak page.
Where do Bellflower permits come from?
Building and Safety, shown under the city's Planning department, at 16600 Civic Center Drive, phone (562) 804-1424. Water heater replacements, gas piping changes and repiping normally involve a permit, and state rules assign permitted work to a contractor. In an apartment building, the owner usually signs off on that work, not a tenant.
SoCalGas supplies gas in Bellflower, although the city's water page does not mention gas. Its emergency number is 1-800-427-2200. A gas smell in a multi-unit building means every household leaves, and the report goes in from the sidewalk, with 911 added if anyone is in danger.
Which water company serves my Bellflower street?
Four different companies supply Bellflower, split by block, and your bill names the one for your address. The city publishes the list of all four, with a phone number for each, so you can call the right company about low pressure, discolored water or a main break:
- Bellflower-Somerset Mutual Water Company, (562) 866-9980
- Liberty Utilities, (562) 923-0711
- Bellflower Home Garden Water Company, (562) 531-8586
- California American Water, which took over the former Bellflower Municipal Water System customers, (888) 237-1333
We could not verify a hardness figure for any of the four, so check the report from your own company. The company owns the main and the service line to the meter. If water runs through the street or the whole block loses pressure, phone them. A plumber takes over at the meter, and the high water bill page is a good place to start if the meter keeps turning.
Does Bellflower's housing mix affect water heater choices?
It can. A single-family owner chooses a heater on cost and lifespan, while a building owner may need to serve several units from one system or replace a heater in each. Pros and cons of each type are in the tank versus tankless comparison. In a rental, the existing heater's location and venting often limit what can replace it, and a plumber can say so at the visit.
For owners of the 9,352 owner-occupied homes, the usual advice applies: replacement is easier on your schedule than on the day the old tank fails, and a quote in hand beats a rushed decision.
Common questions
Is it OK for a Bellflower tenant to book a plumber without the landlord?
Nothing stops you, but it can cost you. Without the owner's agreement, you may not be reimbursed, and work on shared pipes may not be yours to authorize. Tell the owner first, in writing. If the landlord agrees, the plumber's written quote can be sent to them for approval.
Why does my Bellflower water bill come from a company I have never heard of?
Several small and private companies serve different streets, and the city's own page names four of them. Names like Bellflower-Somerset Mutual or Liberty Utilities appear on bills for that reason. A change of provider across a street is normal, not a billing error.
The water just stopped in my building. Now what?
First check whether neighbors are affected. If the whole block is dry, call the water company named on your bill. If only your building or unit is dry, check the shutoff valves and tell the property manager. A plumber can then look at the supply into the building and the valve that controls your unit.
Every area we cover is listed on Whittier plumber.